5
[
] sets the high-pass filter (subsonic protection filter) at a cut-off of 20 Hz.
[Position 2] should ONLY be used in audio systems featuring larger and rugged loudspeakers
capable of handling subsonic/bass frequencies at FULL power!
It is recommended that [Position 2] is only used in audio systems featuring rugged 8”-10”
woofers or similar high-performance/high-power subwoofers!
[
+
] sets the high-pass filter (subsonic protection filter) at a cut-off of 32 Hz.
[Position 3] should be used in audio systems featuring high-quality floor standing fairly rugged
loudspeakers capable of handling bass frequencies at high power.
It is recommend that [Position 3] is used in audio systems featuring rugged 6”-8” woofers or
similar high-performance/high-power subwoofers!
[
.
] sets the high-pass filter (subsonic protection filter) at a cut-off of 40 Hz.
[Position 4] should be used in audio systems featuring high-quality bookshelf or general-
purpose loudspeakers!
Copland recommends that [Position 4] is used in audio systems featuring small or general-
purpose woofers or similar standard subwoofers!
Important note: The [High-Pass] selector is set DEFAULT at [Position 3] !
Important note: Do NOT change the default setting to a lower value, unless you
are sure that your loudspeaker as minimum fulfils our recommendations!
Important note: Copland cannot be made liable for any damage to external
equipment used with the unit.
. /
%)
'
%
&
3.5mm Jack connector for the measuring microphone.
The Microphone connection is only used during set-up and calibration of the unit and the audio
system.
Connect the measuring microphone to the Microphone connection before set-up and
calibration of the unit and your audio system.
Disconnect the measuring microphone from the unit after set-up and calibration is done!
The microphone do not need to be connected to the unit during playback
operation. The microphone has no operational functions during playback.
Reduce the volume control on the amplifier (or pre-amplifier) during connection or
disconnection of the microphone! This provides optimum protection to our
loudspeakers.
Important note: The DRC205 is calibrated to the featured microphone!
The microphone are calibrated for optimum performance.
Important note: Do NOT connect an other microphone to the unit without running a
microphone calibration!
Important note: Do NOT connect any third-party microphone to the unit! The
microphone calibration will NOT work with third-party microphones!
Summary of Contents for DRC205
Page 1: ...1...
