Tools required
Allen wrench
2
Support leg leveler
Step 3:
Install the bed legs
Keep the deck upright or bottom-up.
Align each leg plate with pre-drilled
holes on the Deck Corner Block (
Figure
3
). Tighten the
¼” x 20 -20mm hex bolts
with provided Allen wrench (
Figure 4
).
Figure 3
.
Leg Installation Patterns
Wooden Tapered Leg
pre-drilled holes
Metal Hairpin Leg
pre-drilled holes
Figure 5
.
Adjust leveler on
Deck Corner
Block
Deck Corner
Block
Hairpin Leg
¼” – 20 x 20mm
hex bolts
Corner Block
Step 4:
Level the bed
Lay the bed on the floor (
Figure 5
).
Retract the leg leveler slightly so that it
only makes contact with the floor when
weight is applied to the fully assembled
bed.
Figure 4
.
Install Bed Legs
support leg
Step 5:
Adjust headboard height (optional)
The
headboard
panel
height
is
adjustable. The headboard
uprights
are
pre-installed on the headboard. A higher
positioned headboard can be achieved
by releasing two
¼” – 20 x 35mm hex
bolts on each upright, then aligning and
re-tightening with Hole #2(s) and Hole
#4(s) on the back of the headboard
(
Figure 6
).
Hole #1
Hole #2
Hole #3
Hole #4
¼”-20 X 35mm hex bolt
Figure 6
.
Adjust headboard
