3. Locking wheel
6M. Sausage tube
7M. Meat/food pusher
5M. Hopper plate
2. Mincing tube
1M. Fixing ring
Sharp side
Smooth side
2M. Grinding disk
4M. Feed screw
3M. Mincing blade
(fit smooth side first)
HOW TO ASSEMBLE THE BLENDER JUG
1. Measuring cup
2. Lid
3. Blender jug
4. Sealing ring
5. Blade unit
6. Base
Assembly of the Glass Blender Jug
Note this may already be part assembled.
1. Put the rubber sealing ring (4) on the inner edge of the blade unit (5)
2. Put the blade unit (5) with sealing ring into the base (6).
3. To fit the lid, simply push into place, aligning the cover with the spout for a
secure fit, and allowing no gaps.
4. Ensure the measuring cup (1) is also fitted – align the tabs and turn clockwise
until secure.
5. Mount the blender jug (3) onto the top of the food mixer (top housing part 10
on parts diagram). Ensure it is fully pressed in.
6. When the blender function is no longer required, always replace the blender
cover (part 21 on parts diagram). The other food mixer functions will not work
without this cover.
7. Note: The measuring cup is marked >PS< but this has no meaning.
To Assemble:
• Turn the locking wheel (3) on the main body of the mixer anti clockwise as far
as it will go.
• Insert the mincing tube (2) and then tighten the locking wheel clockwise to
secure in place.
• Place the feed screw (4M) into the mincing tube, long end first and turn until it
is fixed in place.
• Place the mincing blade (3M) onto the feed screw shaft with the blade facing
away from the machine (smooth side first). Take care as the blade is sharp.
• Place the desired grinding disc or attachment next to the cutting blade, fitting
the side protrusions in the slots.
• Then turn the locking ring clockwise until tight. Do not over tighten.
• Place the hopper plate on the mincing tube as shown.
BEFORE FIRST USE
All parts of the food mixer should be thoroughly cleaned before first use.
See Cleaning section.
Unwind the cable from the base of the food mixer and plug into the mains
supply.
HOW TO USE THE FOOD MIXER
Operation Guide (see parts diagram for numbers in brackets)
1. Ensure that either the blender jug or the blender
cover is fitted. The food mixer will not work without
either of these fitted as there are small power tabs
located here that are depressed when the jug or
blender cover is fitted completing the circuit. Take
care not to damage these tabs at any time (see photo,
left).
2. Press the locking switch (5) downwards, then lift the machine arm.
3. Place the mixing bowl (4) onto the base, and turn to lock it as the arrowhead
(21) denotes (anti clockwise).
4. Fix the clear plastic bowl cover into place, aligning the tabs and then twist anti
clockwise to lock. There are arrows on the cover to guide you. Do not force the
cover as it may cause damage to the cover. Ensure the filling hole for adding
ingredients is facing towards you. The covers may be stiff to begin with. As
with any new product, these will loosen after the first few times they are used.
5. Fix the splash cover (13) onto the blade of your choice.
6. Then lock the blade into the machine tightening the knurled nut (23)
clockwise.
7. Press the locking switch downwards, then push the machine arm down and
ensure it is securely closed.
8. Plug into the mains power socket. Press the I/R switch to I and select the
required speed by turning the speed dial (15).
