Wireless Doorbell
10566
Instructions for Use
Please read and retain these instructions for future reference
v002:30/03/17
For Transmitter:
NOTE: Please first test whether the operating range you selected is working.
Transmitter Installation Method 1: Screw/Anchors (Preferred installation method)
1.
After choosing the location of installation, use a flat screwdriver to open the front cover of the
transmitter to remove the battery.
2.
Locate the two marked wall mount openings under the holes in the PCB board (see the below
structure diagram) and create an opening with a screwdriver or an electric drill.
1.
Drill holes in the wall with an electric drill. Insert the 2 expansion (anchors) bolts provided in the
package. Replace the back cover on the PCB board. Reinsert the battery and the front case,
aligning the battery cover in the correct position to put it back on. The installation is complete.
Transmitter Installation Method 2: Adhesive sticker
(Optional installation method)
Please clean the installation area with a cloth to clean the surface.
1.
Test the operating range between transmitter and receiver. Prepare a flat area where you
intend to install the transmitter.
2.
Tear off one side of the double-sided adhesive sticker. Stick the transmitter onto the wall and
press it for 10 seconds. Please note that the adhesive sticker will have poor adhesion if put on
dirty or uneven surface. Sunlight or rain will affect the adhesion and may cause the transmitter
to detach from the surface.
Operating Instruction
1. Mode Selection
There are 4 modes for selection:
Mode A: When you press the button on the transmitter, the LED light on the receiver will be flashing
without sound.
Mode B: When you press the button on the transmitter, the flashing receiver will be ringing without
the light flashing.
Mode C: When you press the button on the transmitter, the LED light on the flashing receiver will be
flashing and the flashing receiver will be ringing together.
Mode D: Turn off the flash receiver.
* Notice: When the flashing receiver is powered by lithium battery only, the LED light will be on when
the receiver is turned on.
2. Volume Selection
There are 4 levels of volume to select. Locate the volume change button on the left-hand side of the
receiver and press this button repeatedly to get the desired volume level.
+ve
