![background image](http://html1.mh-extra.com/html/coopers-of-stortford/g295/g295_instructions-for-use-manual_2665360007.webp)
Vertical CD Player G295 Instructions for Use
Please read and retain these instructions for future reference
v002: 15/05/20
B. INSTALLING BATTERIES INTO THE REMOTE CONTROL
The remote control operates on one CR2025 battery (included). To
activate the remote control, remove the insulation tab inserted in
the battery compartment. When the operation of the remote
control becomes intermittent or unsatisfactory, replace the
original battery with a new CR2025 lithium
battery.
1.)
Slide out the battery holder from the remote control case.
2.)
Replace the 3V CR2025 battery. Be sure the battery is installed
correctly.
3.)
The remote will not work if the battery is installed with the
wrong polarity.
4.)
Insert the battery holder back into the battery slot.
USING THE REMOTE CONTROL CORRECTLY
Note: The Remote Control is only for operating the CD/USB ,AU,BT Player and Radio.
Point the Remote Control at the remote SENSOR (IR) located on the front of the System.
The functions of the remote buttons are the same as the corresponding controls on the main unit.
The performance of the Infrared SENSOR may be degraded causing unreliable operation if there is
strong ambient light source in the same room.
The recommended effective distance for remote operation is about 10-15 feet.
MUTING
The volume is muted temporarily when pressing the MUTE button on the remote control. Press again to
restore the volume.
FM RADIO OPERATION
1.
Tap the
STANDBY
Button
on main unit or remote control to turn on the unit.
2.
Tap the
MODE
Button
on main unit or remote control to select FM mode, the FM radio frequency
appear in display.
3.
To manually tune to a specific radio station, tap the
or
Button
on either main unit or remote
control repeatedly. Use the manual tuning method to tune in weaker stations that are bypassed during
Automatic Tuning.
4.
To automatically tune to the next available radio station, press and hold the
or
Button
on
main unit or remote control for 1-2 seconds until frequency readout on the display begins to scan and
then release the button. The tuner will stop scanning when it receives the next broadcasting station of
adequate signal strength.
5.
Press the volume control on main unit or remote control to adjust the volume control to the desired
volume level.
FM & FM Stereo reception
-
When listening to the FM radio, press the
ST./MONO Button
on remote control to switch between
stereo mode and mono mode. The FM stereo icon “ST” will appear on the display if unit is in stereo
mode. It is preferable to receive the program in mono when you are receiving a weak station.