2 in 1 Car Heater
F908
Instructions for Use
Please read and retain these instructions for future reference
v001: 03/06/19
The Heater base can be mounted to the vehicle using mounting screws or can be mounted using the
adhesive strip as desired.
Mounting with Screws
1.
Make certain that the power cord is long enough to reach the 12V auxiliary power outlet from the
mounting location.
2.
Use the mounting base as a guide to mark two holes in the mounting location.
WARNING! TO PREVENT FIRE: Verify that installation surface has no hidden wires or other
components before drilling or driving screws.
1.
Drill pilot holes in the desired surface slightly smaller in diameter than the shaft of the mounting
screws.
2.
Align the holes in the mounting base with the drilled holes.
3.
Mount the mounting base using mounting screws.
Mounting with Adhesive Strip
1.
Make certain that the power cord is long enough to reach the 12V auxiliary power outlet from the
mounting location.
2.
Wipe the base with alcohol for a grease-free surface. Allow the alcohol to evaporate.
3.
Peel off one face of the adhesive strip. Place the strip on the face of the base and press down and hold
for one minute to adhere.
4.
Prepare the mounting surface on the car following the same procedure as indicated in the above
mentioned paragraph.
5.
Peel the strip backing carefully and position the base on the surface and press into place. Leave in place
for an hour before use.
Maintenance
Procedures not specifically explained in this manual must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn both switches to their “ from its outlet, and allow it to cool completely before performing any
inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM DEFROSTER FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before
further use.
1.
BEFORE EACH USE, inspect the general condition of the Heater. Check for:
a.
loose hardware,
b.
misalignment or binding of moving parts,
c.
cracked or broken parts,
d.
damaged electrical wiring, and
e.
any other condition that may affect its safe operation.
2.
AFTER USE, wipe external surfaces of the Heater with clean cloth. Do not use flammable liquids or
harsh detergents to clean the Defroster. Do not submerge in liquid.
3.
Store the Heater in a dry location out of direct sunlight. Keep the Heater out of the reach of children.
4.
Replace fuse with the same type and rating only.
