3 in 1 Garden Vacuum
9255
Instructions for Use
Please read and retain these instructions for future reference v005: 17/04/19
Mounting the handle
Fig. 1
To mount the handle press the button at
the rear top of the vacuum/blower unit,
pull the upper handle arm upwards until
it locks in position.
Adjust the telescopic handle. Turn the
height adjustment knob anti-clockwise
and adjust handle height to proper
position. Hand tighten the knob by
turning it clockwise – see below:
Before starting
Fig. 2
MAKE SURE NOT TO DAMAGE THE
MAINS CABLE. ( Fig.2 A)
It is recommended to connect the
machine to the mains supply over a
residual current operated device with a
maximum breaking current of 30mA.
Always use a weatherproof extension
cable with high-performance insulation
approved for outdoor use.
1.
Make sure that the handle is properly attached and is firmly seated in the chassis (see Fig. 1).
2.
Always make sure that the collecting bag is attached and locked into position before you switch on the
device (both in vacuum and blower mode)
If it is not locked into position, the garden vacuum will NOT
start(see Attaching the Collecting Bag).
3.
Your wheeled vacuum/blower unit is controlled via the on/off switch (Fig.2) at the handle (2). Make sure
that the switch is in the Off position.
4.
Connect the unit to an extension cable. Lead the extension cable through the handle and around the
strain relief(Fig.2).
