2.5L Black Instant Water Boiler
11102
Instructions for Use
Please read and retain these instructions for future reference
v001: 06/03/18
Page No. 3
2. Dispense water:
Make sure the plug is connected to the proper wall outlet, and fill water tank with water. Place your
cup on the removable water tray. Make sure the cup is aligned with the spout. Press the button
once and the blue light turns on. After about 5-8s,hot water is dispensed. If you press the button
twice, the green light turns on and continuous hot water is dispensed. When you have obtained
your desired amount of water, press the button again and the appliance stops working at once.
If there is not enough water in the water tank, the blue light and the green light will flash
alternately.
To obtain hot water again, repeat the above procedure.
Caution:
In the event of the ON/OFF switch malfunctioning and preventing water flow from stopping, stop
using this immediately.
Switch off from the mains plug socket and unplug immediately.
Remarks:
Do not touch the boiled water and steam to avoid risk of scalding.
The appliance has a manual thermostat to reset
the heating function. If the unit has no power, has
stopped working or does not dispense boiling
water, you can reset the thermostat by pressing
the reset button.
3. Water disposal from the water tray
When the water tray is full, stabilize the appliance with one hand and grasp the water tray. Use the
other hand to lift up the water tray slightly to remove it. Empty the water tray and insert it into the
original place with proper force.
After emptying and cleaning the appliance, turn the appliance upside down to open the
drainage stopper in order to clear the drip tray from waste water. Tighten the drainage stopper
after opening it. Ensure this is tight to avoid leakage.
Note: If water is leaking from the bottom the drainage stopper needs to be tightened.