3
COOPER LIGHTING SOLUTIONS
IB519099EN
Installation instructions
Installation Instructions – Commercial LED Wraparound
Figure 6.
Figure 7.
8. Turn breaker on and energize the fixture to verify light
turns on.
5. Make electrical connections according to code.
6. Install driver enclosure cover by reversing the process
to remove the enclosure. Make sure all wires stay
inside the enclosure.
7.
Install the lens by starting at one end, guide the sides
of the lens between the light seal and the outer sides
of the end cap (Figure 6). Squeeze lens with both hands
so lens groove catches the lip on the fixture housing
(Figure 7). While squeezing lens onto the housing, slide
the lens towards end of fixture and push lens under the
tab on the end cap. After lens is fully seated in the end
cap, start pushing the lens toward the housing. After
the lens is attached to the housing, move the lens side
to side to make sure it centered in between the tabs
on the end caps. Slightly pull down on the lens to make
sure it is completely seated.
Guide Lens
Between Gap
Guide Lens
Between Gap
ROW MOUNT INSTALLATION
1.
Remove lens and driver enclosure, per the instructions
above.
2. Remove the 7/8” knockout on the end cap (Figure 8).
Figure 8.
1/4” Row Mount
Alighment Holes
7/8” Knockout
3. To align row mounted fixtures, drill thru 2 alignment
holes in the end cap using a 1/4” drill bit (Figure 8).
4. With the knockout and 2 holes opened, insert
corresponding wiring thru 7/8” hole. Use #10 or #12
bolts and nuts (supplied by others) in the two holes to
align and hold fixtures together.
5. After the electrical connections have been made,
reinstall driver enclosure and lens per instructions
above.
