496
930
Page
17
3. After an Alarm
When your system raises an alarm you must
disarm
it in order to switch off
the sounders and strobes. The system keeps a record of which zone(s)
triggered the alarms, and shows the zone number(s) on the keypad display.
Once you have disarmed the system, you must
reset
the system before you
can start using it again.
Fire Alarm
The system gives a fire alarm by sounding a warbling tone from the keypads
and alarm sounder. The display shows the letters "
Fire
".
1. Evacuate the premises and call the Fire Brigade. Do not attempt to unset
the alarm.
2. When the premises are safe, follow the instructions below.
Disarming the System
If the system is full set then:
1. Go to the keypad via the entry route.
2. Key in your access code or present a tag
The sounders go quiet and the
system gives a double "beep" to
show that it is unset. The
keypad display shows alarm and
the zone number of the first
detector to be triggered. You
may also see the
s
lamp
glowing.
"beep beep"
3. Establish the cause of the alarm.
4. Carry on to reset the system.
Resetting the System
There are three different methods for resetting. You can tell which method
your system uses by looking at the
s
lamp after an alarm.
• If
the
s
lamp is off then the system uses
Customer Reset
. You can
reset the system yourself from the keypad.
• If
the
s
lamp glows after an alarm then your system uses
Engineer
Reset
. Call your alarm company and ask for an engineer to visit the
premises to reset the system.
Zone 02
