INS #
049-242
Installation Instructions for the EUX Universal Edge Lit Exit – AC Only
Instructions d’installation pour enseigne de sortie à éclairage périphérique
universelle EUX - CA seulement
Instrucciones de instalación para la señal de salida universal de iluminación de
borde EUX -CA solamente
WARNING
Risk of Fire/Electric Shock
If not qualified, consult an electrician.
WARNING
Risk of Electric Shock
Disconnect power at fuse or circuit breaker before
installing or servicing.
Important Safeguards
WHEN USING ELECTRICAL EQUIPMENT, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
OBSERVED INCLUDING THE FOLLOWING.
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2. Dry location only. Do not use outdoors.
3. Do not use in hazardous locations, or near gas or
electric heaters.
4. Do not let power supply cords touch hot surfaces.
5. Do not use this equipment for other than the
intended use.
6. Installation is to be performed only by qualified
personnel.
7. Install in accordance with National Electric Code
and local regulatory agency requirements.
8. The use of accessory equipment not
recommended by the manufacturer may cause
an unsafe condition.
9. Equipment should be mounted in locations and
at heights where it will not readily be subjected
to tampering by unauthorized personnel.
10. SAVE THESE INSTRUCTIONS
For Recessed Installation
1. Turn off power supply.
2. Determine if the fixture will be mounted in the
ceiling or the wall.
3. Remove the screws securing the trim plate to the
housing (See Figure 1). Place the trim assembly
and screws aside and save them for later
installation. It is not necessary to disconnect the
wire harness connecting the charger driver circuit
board to the LED board. Instead, the trim plate
can be hung from the sliding plastic installation
hook (see figure 2).
Housing
Plastic
Installation
Hook
Trim
Assembly
Figure 2
Trim Plate
Housing
Figure 1
