3
• For end mount, remove the endcap on the desired
end, and replace it with the canopy and guide bracket
(See Figure 8). Replace the cover plate over the hole in
the center of the housing.
4. Remove the screws securing the trim plate to the
housing (See Figure 1). Place the trim assembly and
screws aside and save them for later installation.
It is not necessary to disconnect the wire harness
connecting the charger driver circuit board to the LED
board. Instead, the trim plate can be hung from the
sliding plastic installation hook (See Figure 2).
Secure the canopy to the junction box using the
adapter plate and screws provided (See Figure 7/8).
The adapter plate is designed to be connected to a
NEMA standard 3.5” round, 4” round, 3.5” octagon,
4” octagon, or handy (single gang) box. However,
it is possible to connect the adapter plate to other
electrical boxes with some modification.
5. Connect power supply and ground in accordance with
NEC and local codes. Wire connections are as follows:
Ground to Green Lead, Neutral to White Lead, 277V
line to Orange Lead (if used), 120V line to Black Lead
(if used). Cap unused Line Lead. (See Schematic)
6. If the fixture is to be wall mounted, first, loosen the set
screw on the back of the pivot housing. Then remove
the locking clip by sliding it to the end of the pivot
housing (See Figure 6). Rotate the pivot housing 90
degrees, and then replace the locking clip. Tighten the
set screw.
7. Remove the trim assembly from the installation hook.
8. Replace the screws holding the trim assembly to the
housing.
9. Lens is provided in a separate box. Apply chevrons
and background as needed. Snap lens into place.
NOTE: If using the lens with the default transparent
background (instead of the provided white or mirror
backgrounds) it must be installed only where there is
adequate color contrast between the sign legend and
the interior wall finish behind the sign, to provide for
sufficient visibility.
10. Turn on power to fixture.
MAINTENANCE: None required.
NOTE: Servicing of any parts should be performed by
qualified personnel. Only use replacement parts
supplied by Cooper Lighting
Solutions
. Use of
unauthorized parts may void the warranty.
TROUBLE SHOOTING HINTS:
If LED display or charge indicator LED does not
illuminate, check the following:
1.
Check AC supply – verify that unit has 24 hour AC
supply.
2.
Unit is shorted.
3.
If following the above trouble shooting hints does not
solve your problem, contact your local Cooper Lighting
Solutions
representative for assistance.
SCHEMATIC:
Voltages and wire colors may vary for international
versions. Check wire tags.
Installation Instructions for the EUX Universal Edge Lit Exit – AC Only
Installation Instructions for the EUX Universal Edge Lit Exit – AC Only
049-242 ADX141173 www.
cooperlighting
.com
Housing
Cover Plate
Adapter
Plate
Guide
Bracket
Canopy
Figure 8
041-1389
c
REMOTE
LED_Out LED_In
W`
O
B
JP5
JP7
C1
0
C1
1
JP1
JP6
+
C8
+
C7
+
C1
2
CN1
L1
CN2 ICSP
JP2
MO
V1
MO
V2
F1
JP3
JP4
C1
W7
PS1
W8
JK1
c
CN1
LED11
LED1
LED2
LED3
LED4
LED5
LED6
LED7
LED9
LED10
LED8
Orange Lead - to 277V
Black Lead - to 120V
White Lead - To Neutral
Driver PCB
LED PCB
