Turn OFF
power at the
circuit breaker.
Disconnect the wiring and remove both switches.
Turn OFF
the light using one of the
switches.
Turn OFF power
at the circuit
breaker.
Remove the wall plates
from the existing light
switches.
Leaving wiring attached
, remove screws and pull
the switches away from the wall. Verify that
BOTH
switch
locations
have a neutral wire available. If
not, stop and consult a licensed electrician.
Neutral
1
2
Accessory
8
9
3
At each switch location, place electrical tape or a label on
the wire connected to the different colored screw terminal
(common).
Ensure wiring is safely separated and terminals are not
touching anything, and then
turn ON power
at the circuit
breaker.
4
5
DO NOT TOUCH EXPOSED WIRE OR TERMINALS.
Using a
voltage tester, determine which switch location has power
on the tagged wire.
(The powered location is connected to the breaker
while the unpowered location is connected to the switched load.)
Use tape or label to tag the powered switch location
“ACCESSORY”. Label the other switch location “SMART”.
Accessory
6
7
Smart
Smart
3-WAY INSTALLATION (2 Switches)
ON
OFF
OFF
HOT
HOT
