Connect the HALO Home Smart
Switch
(A) using provided wire nuts
(B).
i. Connect the tagged ‘Hot’ wire to the
Smart Switch’s black wire.
ii. Connect the bare copper or green
ground wire from the wall-box to
the Smart Switch’s green wire.
iii. Connect the other switch wire (load)
to the Smart Switch’s red wire.
iv. Connect the neutral wire in the
wall-box to the Smart Switch’s white
wire. (NEUTRAL IS REQUIRED).
Turn OFF
power
at the circuit breaker
Use a label or electrical tape to
tag
the identified ‘Hot’/power wire
.
Disconnect the wires
and remove the
switch.
HOT
Using the screws provided (C),
mount the Smart Switch
in the wall-box
and attach a wall plate (not included).
Turn ON power
at the circuit breaker. (An LED indicator
will start flashing when power is turned ON).
Using your smart phone/tablet, follow the online Quick Start Guide to pair this product to your HALO Home account.
BringHaloHome.com
Turn OFF power
at the circuit breaker
and
remove the wall plate
Leaving wiring attached,
pull the
switch away from the wall.
Verify that there is a neutral wire
available.
If not, stop and consult a
licensed electrician.
Turn the wall switch to the
OFF
position
but keep wires connected.
Ensure wiring is safely separated
and terminals are not touching
anything, and then
turn ON power
at the circuit breaker.
DO NOT TOUCH EXPOSED WIRE OR
TERMINALS. Using a voltage tester,
determine and note which wire still
has power
(‘Hot’).
HOT
4
1
7
10
11
13
12
5
2
8
6
3
9
SINGLE-POLE INSTALLATION (1 Switch)
ON
ON
OFF
OFF
