If there is more than one control location for the same lighting or switched load
(3-way or 4-way), additional HALO Home products will be needed:
•
One location will need a
HALO Home Smart Switch
. This will operate as a single-pole
switch turning ON/OFF the lighting load.
•
The other switch location(s) will require
HALO Home Accessory Switches*
. These will send
wireless signals to the Smart Switch which will turn ON/OFF the lighting/load.
*
Other HALO Home Controllers like the Accessory Dimmer, Anyplace Dimmer or Multi-Room Scene
Keypads can also be used.
Wireless Signal
Constant Power
In-Wall Smart Switch Installation Instructions
HIWMAS1BLE40A
•
Turn OFF circuit breaker or remove fuse(s) and test that power is
off before wiring or servicing.
•
Never wire any electrical device with power turned on. Wiring
device with power on may cause permanent damage to product
and void warranty.
•
If you are not sure about any part of these instructions, please
contact a licensed electrician.
•
Minimum 75°C supply conductors
•
Edges may be Sharp - Wear gloves while handling.
•
Connect switch to a 120 volt, 60 Hz power source. Any other
connection voids the warranty.
•
Fixture should be installed by persons with experience in household
wiring or by a qualified electrician. The electrical system, and
the method of electrically connecting the fixture to it, must be in
accordance with the National Electrical Code and local building codes.
ONLY USE WITH NON-SMART LIGHTS
PACKAGING CONTENTS
SINGLE LOCATION OVERVIEW
ITEMS REQUIRED (Purchase separately)
A. Smart Switch B. (4) Wire Nuts C. (2) Screws
• Philips Screwdriver
• Labels or electrical tape for tagging wiring
• Voltage tester
• Tape or labels (3- or 4-way wiring)
• Gloves
The HALO Home Smart Switch requires a neutral wire for operation. If there is no neutral wire at the current switch location,
contact a licensed electrician for installation.
The HALO Home Smart Switch easily replaces a single location standard switch to allow incandescent, LED/CFL loads, or small
motor loads such as a ceiling or exhaust fan to be turned ON and OFF by the HALO Home App and HALO Home controllers.
Max Loads:
720W Incandescent, 600W LED/CFL/FL/ELV, 600VA MLV, 1/2 HP Motors
A.
B.
C.
MULTI-LOCATION CONTROL OVERVIEW
TIPS: When retrofitting existing 3-way
or 4-way locations:
• Verify that there is a neutral wire at
EACH switch location. (White wires
connected to switch terminals and
marked with electrical tape are
typically
NOT
neutral wires.)
• Only 1 HALO Home Smart Switch will
be used in the circuit.
• The HALO Home Smart Switch must
be directly connected to the
lighting load.
• HALO Home Accessory Switches
cannot wire downline of a Smart
Switch. They require a constant hot
feed (unswitched and undimmed).
• HALO Home Accessory Switches can
be powered from a different circuit
than the lighting/Smart Switch if
necessary.
3-way and 4-way wiring can be
confusing. If wiring does not match
diagrams shown, stop and consult with
an electrician.
ENGLISH
