EN
G
L
ISH
3
Call for customer service and/or missing or damaged parts (800-334-6871)
Note:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Fixture must be connected to a 120 Volt, 60 Hz power source. Any other
connection voids warranty.
• Total wattage of light bulbs connected to the motion detector cannot exceed
500 watts incandescent / tungsten / halogen.
• This motion detector should be installed by persons with experience in
household wiring or by a qualified electrician. The electrical system, and the
method of electrically connecting the fixture to it, must be in accordance with
the National Electrical Code and local building codes.
• For supply connections, use wire rated at least 90˚C.
• For proper operation and protection against damage, the motion detector
head adjustment knobs must be facing the ground.
• Disassembly of your fixture will void the warranty.
For best results
• Install your fixture 8-12 feet above ground (motion
detector is less sensitive above 12 feet).
• Locate fixture so motion moves across detection
zone (Fig.1).
• Locate fixture away from heat producing sources
to prevent false triggering. Also be very careful
not to include objects such as windows, white
walls and water in the detection zone whenever
possible.
• Locate fixture away from moving objects such as trees and street traffic.
• Do not install more than one motion detector on one wall switch.
Fig. 1
MS180_W 825-0216.qxd:MS180 325-1553.qxd 6/26/08 2:58 PM Page 3