Cover plate
1/4-20 x4"
(2x)
Exploded view and part call-out
Hex bolt
Canopy
(2x)
Wiring the fixture
. Replace canopy and secure using both set screws.
(2x)
Set screw
Fixture head
#8-32 x3/8"
assembly
1.
Remove both 1/4-20 x4 hex bolts from bottom of pendant.
2.
Remove both #8-32 x3/8" set screws and allow canopy to
slide down pendant.
3.
Run wires from J-box into pendant, ensure there is enough
wire to reach cover plate.
4.
Using appropriate fasteners, secure fixture to ceiling.
Use
additional bracing around J-box to support fixture.
5
Aiming the fixture
Attention:
Large fixtures require additional bracing/structure
around J-box to support fixture.
Secure cover plate
1/4-20 x4
1.
(2x)
Hex bolts
properly matched
Slide fixture assembly onto pendant and secure with both
Attach appropriate wires and ensure all connections are
1/4-20 x4 hex bolts.
2.
Cover plate
3.
1.
To aim fixtures, loosen both #10-32 end screws on
one
fixture. When both indicators are lined up, the slope of the
lens face is 40-degrees. Each subsequent notch is an
addi/- 10-degrees.
2.
When fixture head is rotated to the desired angle, retighten
end screws to secure the position.
3.
Repeat for second fixture head.
Fixture head
indicator
indicator
Yoke arm
#10-32
End screw
Mounting pendant to ceiling
Cover plate
#8-32 x3/8"
(by others)
J-box
3/8" fasteners
(by others)
Canopy
Set screw
(2x)
1/4-20 x4
Hex bolts
(2x)
These installation instructions are valid with the above Ametrix styles.
Sheet 1 of 3
that all sources of power are turned off. All
1
Visor and Non-Visor
3
Warning
2
performed by a certified electrician.
: Before starting any work ensure
work must meet local/national codes and be
Do not
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
Large, INDOOR
P2R
(P
endant
, 2
-way
, R
emote ballast
)
ADY071471 REV A(ECN070347)
