3
COOPER LIGHTING SOLUTIONS
IB51915121
Installation instructions
Installation Instructions – Fail Safe Narrow (FSN)
8. Tuck all wires and wire nuts into the fixture junction box,
replace electrical access plate, and fasten screw
(Figure 6).
ote:
N
This fixture is compatible with 0-10V dimming.
If installing dimming wires follow your dimmer
instructions for wiring to the violet (Dim +) and pink
(Dim –) leads.*
* Constructions built before Jan 2022 may have gray wire
for 0-10 dimming control present. In these cases, the
installer will label the gray building wire as a 0-10 dimming
wire and connect to our product’s pink 0-10V dimming
control wire. Reference NFPA70 (2020 NEC), section 410.69.
7. Bring supply wires into the junction box using a conduit
fitting through the top access plate. Connect the
line (black) and neutral (white) to the supplied quick
disconnect. Attach ground wire to the ground screw on
the access plate.
Figure 5.
Figure 6.
Figure 7.
Violet
Ground
Pink
White
Black
White
Pink
Violet
Black
Figure 8.
9. With fixture powered on, use the lumen switch and CCT
switch (if equipped) to adjust the fixture to the desired
lumen level and CCT (Figure 7). Refer to label on top of
driver for lumens and wattage of each setting.
10. Once desired lumen level and CCT have been selected,
attach provided switch cover securely using provided
screws. (Figure 8.)
11. To clean fixture, use a small amount of water on a cloth
and wipe the lens. Do not use chemicals on the lens as
this could cause damage.