Startup
When a Chilli Control Panel is powered up the LEDs in all the buttons will flash once and then go off.
The panel then goes into its default state with all the button LEDs off, except for the 10 button panel in which the
“1-6” button only is lit.
All Chilli Control Panels are initially assigned to Area 1.
To assign a control panel to a specific area number (1 - 10) carry out the following operation:
1. Press and hold down the Memory 1 and OFF buttons for a few seconds until all the LEDs in the buttons flash.
2. Send a play memory/area message on the network, from another control panel, master controller or dimmer.
3. The control panel is assigned to the area number in the message.
4. Press the Memory 1 or OFF button to exit setup mode.
Memory 1: Press the ‘1’ button.
Memories 1 - 4: Press the corresponding memory button.
Memories 1 - 4: Press the corresponding memory button.
Memories 1 - 6: Press the 1-6 button (if not already selected), then
press the corresponding memory button.
Memories 7 - 12: Press the 7-12 button (if not already selected), then
press the corresponding memory button.
The LED light in the memory button is lit and the outputs fade to the memo-
ry levels in the memory’s fade time.
To playback (output) one of the memories previously programmed in the Chilli Pro or Spice dimmers on the Chilli network.
chilli
net
OFF
chilli
net
OFF
Two Button
Panel
Five Button
Panel
Seven Button
Panel
Ten Button
Panel
Outputting Memories
OFF
OFF
1-6
7-12
1
1-6
chilli
net
OFF
SEQU
7-12
6
5
1-6
chilli
net
OFF
1
1
Assigning an Area
Operation
