www.cooperbussmann.com/wirelessresources
Cooper Bussmann 945U-E Wireless Ethernet Modem & Device Server User Manual
61
Rev Version 2.14
Select “Blacklist” or
“Whitelist”
Blacklist will prevent all listed devices from accessing the module and using the radio
link. Whitelist will allow devices with the MAC addresses listed to communicate with
the module and utilize the radio link. All other devices are blocked.
Add Entry
Add a row to the table of Mac address filter rules.
Delete Entry
Delete the currently selected MAC address filter rule.
Enable
Select checkbox to enable the rule.
Mac Address
Enter the desired source MAC address.
Save Changes
Saves changes to non-volatile memory (reset is required to activate).
Save Changes and
Reset
Saves to non-volatile memory and restart to activate changes.
IP Address Filter Configuration
The IP filter can be used to permit or deny network access to specific devices through the use of blacklists
(blocking of traffic that matches a rule) and whitelists (allowing traffic that matches a rule). The IP filter entry will
match either source or destination address in the packet. That is, if either the source or destination IP address falls
within the address range specified in the rule, the packet is matched and will be discarded (blacklist) or allowed
(whitelist).
If the protocol is specified, the protocol of the packet must also match. If the protocol is TCP or UDP, the source or
destination TCP/UDP can also be inspected. If the IP address and protocol matches and the source or destination
port number falls within the range specified, the packet is matched.
NOTE Configuration pages use TCP protocol on ports 80 and 443. Create whitelist rules specifying the
configuration PC’s IP address, with TCP protocol, ports 80 and 443.
Select “Blacklist” or
“Whitelist”
Blacklist will prevent all listed devices from accessing the module and using the radio
link. Whitelist will allow devices with the IP addresses listed to communicate with the
module and utilize the radio link. All other devices are blocked.
Add Entry
Adds a row to the table of IP Address filter rules.
Delete Entry
Deletes the currently selected IP address filter rule.
Enable
Select this checkbox to enable the rule.
IP Address Min
IP Address Max
These fields set the range of IP addresses. All addresses within the specified range
are affected by the rule.
Port Min
Port Max
When the protocol is set to TCP or UDP, this is the range of port addresses to which
the rule applies. When protocol is set to All or ICMP, these settings have no effect.
Protocol
This chooses the protocol to which the rule applies. The rule can apply to Any
protocol (All), or to only one of TCP, UDP, or ICMP (Ping).
Save Changes
Saves changes to non-volatile memory (reset is required to activate).
Save Changes and
Reset
Saves to non-volatile memory and restart to activate changes.
