Cooper & Hunter MALTA CH-2835, Instruction Manual

Page: 7 / 20

www.cooperandhunter.com
5
Directions for use
Prior to the first use, especially if outdoor temperature is below zero, let the
device heat up at room temperature for 1 hour. It is recommended to use
the device at temperature ranging from 5°C to 40°C, and relative humidity
not more than 80%. Use only clean water with temperature not more than
30°C. Prior to a switching the device off for a long time (more than 2 days),
drain water from the water tank. Read instructions how to clean the
humidifier in section «Recommendations on maintenance of the device».
6. OPERATION OF THE UNIT
1. Air humidifier - 1 pc.
2. Operation manual - 1 pc.
3. Filter - 1 pc.
5. SCOPE OF DELIVERY
1) Take off the mist outlet cover and put it aside (see Fig.1);
2) Lift up the water tank and turn the water tank nut in counter-clockwise
direction. Take off the water tank nut (see Fig.2). Then add water into the
water tank. After it is filled with water, turn the water tank nut in clockwise
direction to tighten it up;
3) Put back the water tank. Be careful to hold it steadily and put it in place.
Then put back the mist outlet cover (see Fig.3);
NOTE:
Do not pour water into the base of the device - it may fall
into the hole for overflow, and the surface under the device
becomes wet.
An overflow hole is provided in order to eliminate the risk of
water entering the electronic components of the device
through an air-blowing hole.
IMPORTANT!
When moving the humidifier, always hold the device by
the base (Fig. 1), in order to avoid the fall of the part of
the device, with the main electronic components. If there
is water in the device, in order to avoid its entry into the
electronic units through the air outlet (Fig. 2), keep it
horizontal.
4) Insert the power plug to a power socket. LED ring will light up in red.
Humidifier is now under standby status;