Cooper & Hunter CH-FK18SWK2, Installation & Owner'S Manual, Page: 10 / 28

4.
Installation
7
4.1 Installation precautions
4.1.1 To ensures that the installation is performed correctly and that the appliance will
perform perfectly carefully follow the instructions indicated in this manual. Failure to respect
the rules indicated not only can cause malfunctions of the appliance but also invalidate the
warranty and hence the manufacturer shall not respond for any damage to persons, animals
or property.
4.1.2 It is important that the electrical installation is made according to the laws in force,
respects the data indicated in the technical sheet and is correctly earthed.
4.1.3 The appliance must be installed in a position that allows the routine maintenance, such
as filter cleaning.
4.2 Positioning the unit
4.2.1 Avoid installing the unit in proximity to:
-positions subject to exposure to direct sunlight;
-in proximity to sources of heat;
-in damp areas or places with probable contact with water;
-in places with oil fumes
-places subject to high frequencies.
4.2.2 Make sure that:
-the wall on which the unit is to be installed is strong enough to support the weight;
-the part of the wall interested does not have pipes or electric wires passing through;
-the interested wall is perfectly flat;
-there is an area free of obstacles which could interfere with the inlet and outlet air flow;
-the installation wall is preferably an outside perimeter wall to allow the discharge of
condensation outside;
4.3 Minimum installation distances
4.3.1 Figure indicates the minimum mounting distances between the wall-mounted
cooler-convector and furniture present in the room(Fig.5 and Fig.6).
Fig.5
20mm
20mm
90mm
400mm
140mm