Cooper & Hunter Cayman Series, Instruction Manual

Page: 10 / 34

www.cooperandhunter.com
8
Failure to comply with the rules of the section
“Cleaning and servicing the device” can lead to the
development of micro-organisms, bacteria inside the
pan. That will lead to unpleasant smells and violation
of hygienic norms.
Use as much as possible pure water! Water often
contains calcium salts, rust particles and other chemical
elements. Such elements are able to settle on the internal
surfaces of the device, which can lead to breakdown or
difficulties during routine maintenance of the instrument.
IMPORTANT!
3. Do not use soap, solvent or spray
cleaner to clean the transducer and PTC
heater.
To clean the tank (4) and the tank cover (2):
Empty the tank. Remove the tank cover and clean the inside of the tank
with fresh water, vinegar solution or dish washing liquid and cloth or
cleaning brush. Rinse after cleaning with fresh water.
1. Remove the tank cover.
2. Clean the tank, the tank cover with
water using a soft cloth and vinegar if
there are any foam or limescale deposits
on the inside.
3 Rinse the tank in clean water.
To clean the mist nozzle (1):
1. Clean this with a brush or damp cloth.
2. Rinse with clean water.
To clean the filter (12) inside the tank:
Take out the filter from the tank. Clean
the filter which may accumulate large
particles. After cleaning, assemble it
back to the tank.
To clean outer surface of the device:
Wipe the surface of the device with a soft,
damp cloth if needed.
8. TROUBLESHOOTING
In the event of a malfunction under normal conditions of use, please refer to
the following list:
TROUBLE PROBABLE CAUSE SOLUTION
Humidifier does not
operate.
Power cord is not plugged in. Plug in power cord.
The power indicator
light up on, but there
is no mist generated.
Too much water in the basin.
Pour away some water from the
basin.
No mist
The water level in the tank is
too low.
Add water to the tank.
Water is leaking from the tank.
Check that the tank is in the right
position.
The temperature of the unit is
too low.
Place the unit in a room at room
temperature for half an hour prior
to use.
Sediment on the transducer Clean the transducer.