Page 3
Important
Make sure that the voltage marked on the rating
label on the product corresponds with the voltage
in your home.
This quality product has been tested and certified
to meet all applicable UK electrical and safety
standards.
If not already fitted, screw the feet into the bottom
of the cabinet.
The cooler must be installed on a firm flat and level
surface. The feet are adjustable to level the
appliance.
The appliance is designed to operate at normal
room temperatures. Position it away from any heat
source such as a boiler, oven and heater. It is also
not advisable to install the appliance in unheated
locations, such as garages or outbuildings, as
these will impair the operation of the chiller in
winter.
The cooler requires space around the casing for
ventilation and heat dissipation.
Allow adequate space at the rear of the chiller and
do not obstruct any ventilation vents and slots.
Installation
Using the chiller
Temperature control
To keep your wine in perfect condition the
temperature of this chiller can be regulated in steps
of one degree Celsius ranging from 8 to 22°C.
Recommended temperatures for wine storage:
Wine type
Temperature
Red wines
15–18°C
Dry/white wines
10–15°C
Sparkling wines
8–9°C
Setting the temperature
To set the chiller to the recommended temperature
depending upon the wine type to be stored (see
table above), press the ‘
+
’ button to make the
chiller warmer, or the ‘
–
’ button make the chiller
colder.
The display will continue to flash as you press the
button.
When the flashing display shows the temperature
you require release the button.
The display will flash several times to show the
changed temperature.
To check the set temperature press either the ‘+’ or
‘–’ buttons.
The chiller will maintain the set temperature by
switching on and off.
Adjusting display temperature
The display temperature can be changed to display
in Degrees Celsius (C) or Fahrenheit (F), by
pressing the Temperature Display button - ‘
°C/°F
’
FIGURE 2
Switching on
Plug the cooler into a nearby power socket and
switch the socket to ON.
The interior temperature of the chiller will show on
the control panel display. A fan noise will indicate
that the chiller is running.
Interior light
The interior LED light can turned on and off by
pressing the Light button. The LEDs are not
replaceable.
TEMPERATURE
UP (+) BUTTON
TEMPERATURE
DOWN (-) BUTTON
TEMPERATURE
DISPLAY
LIGHT ON/OFF
BUTTON
TEMPERATURE
DISPLAY BUTTON
