Page 3
The adjustable foot under the chiller (Figure 2) can be turned
by hand to make fine adjustments to level the appliance.
Ensure the racks are correctly located in their runners.
Door reversal
If necessary, the door can be reversed by unscrewing the
bottom hinge (see Figure 3). Reposition the door on the
opposite side of the appliance by locating the pin in the hole
on the underside of the fridge top. Completely unscrew the
adjustable foot on the opposite corner, then screw the
adjustable foot into the free hole uncovered when the hinge
was removed.
Replace the bottom hinge on the opposite side of the casing
to secure the door.
Switching on
Plug the chiller into a nearby power socket and switch on.
Leave the chiller running with the door closed for
approximately 2 hours. This will allow the inside temperature
to stabilise.
Installation and controls
Important
Make sure that the voltage marked on the rating label on the
product corresponds with the voltage in your home.
This quality product has been tested and certified to meet
all applicable UK electrical and safety standards.
The appliance is designed to operate at normal room
temperatures. Position it away from any heat source such as
a boiler, ovens and heaters which will reduce the cooling
efficiency of the chiller. It is also not advisable to install the
appliance in unheated locations such as garages or
outbuildings, as these will impair the operation of the chiller
in winter.
The chiller requires space around the casing for efficient
cooling and operation. The minimum clearances are shown
in Figure 1.
The chiller must be installed on a firm, flat and level surface
for it to work quietly and efficiently.
50mm
50mm
50mm
FIGURE 1
The diagram shows the correct air flow
allowance that should be left around the
appliance.
FIGURE 2
FOOT
FIGURE 3
HINGE
PLATE
