Coolworks MWDCK-06CRN1-BK2, Instruction Manual

Page: 11 / 21

NOTE: Top rail and side panels at each side are offset to provide the proper pitch to the rear of
(5/16 ). This is necessary for proper condensed water utilization and drainage. If you are
not using the side panels for any reason, this pitch to the rear must be maintained.
,,
1
A. Hold the side panel in one hand
and gently pull back the center to
free the open end. See Fig.1.
B. Slide the free end "
Ⅰ
" section of the panel
directly into the cabinet as shown in Fig. 2.
Slide the panel down. Be sure to leave enough
space to slip the top and bottom of the frame
into the rails on the cabinet.
Fig.1
Fig.2
"
Ⅰ
"section
Place unit on floor, a bench or a table. There is a
proper
panel for each side. When installed, the flange for
securing the panel in place to the window sill will be
facing into the room.
C. Once the panel has been installed on the side of
the cabinet, make sure it sits securely inside the
frame channel by making slight adjustments.
Slide the top and bottom ends of the frame into the
top and bottom rails of the cabinet. Fig.3.
D. Slide the panel all the way in and repeat on the
other side.
NOTE: If storm window blocks AC, see Fig. 10.
Top Rail
Bottom Rail
Fig.3
Installation Instructions
10
How To Install
left and right side filler panel; be sure to use the