![Coolster ATV-3050C Manual Download Page 12](http://html1.mh-extra.com/html/coolster/atv-3050c/atv-3050c_manual_2661347012.webp)
P22
P23
IMPORTANT ELEMENTS OPERATIONAND RIDES
Cold Start and engine preheating
Note: This car has used to control the operation of brake
motor starter switch. Only in pinch engine brake handle on when
to start. We had closed choke before delivery.
1, the ignition switch will turn to the "•" position.
2,step on the rear brake pedal.(launched inorder to prevent
the car after forward)
3, the upward resistance throttle arm closed, not to refuel the
door.
4, press the start switch.
5, the resistance after heat engine throttle arm downward
completely open.
Note: If the engine can not start, should be released starting
switch, wait a few seconds, then try again. Each attempt, as far
as possible in a short period of time in order to protect the
battery. Each starter not to exceed 5 seconds when the engine.
Note: In order to achieve maximum engine life, before moving
to engine should always be preheated. Not on a Cold-engine
acceleration
Hot engine starter
When the engine has been preheated, then you do not need
closure resistance throttle.
The acceleration engine
Because the cars use Automatic Clutch. So acceleration and
deceleration size only need to control the throttle on the up.
According to the former right hand thumb of increased speed,
deceleration is loosened.
The commissioning Engine
0-1000 km from the motorcycle mileage during your life is very
important for the period. Because the engine is new and in the
meantime we must avoid prolonged Full Throttle or any situation
that could be the super-engine overheating.
1,0 150 km:
Operation and avoid prolonged refueling over 1 / 4 throttle
position. An hour after the operation should cease engine to cool
5 to 10 minutes.
2,150 500 km:
Operation to avoid refueling over 1 / 2 throttle position. At
any time, should not be used Full Throttle operation of this
vehicle.
3,500 1000 km:
To avoid refueling over 3 / 4 throttle position.
4,1000 km long and more:
Full throttle operation should be avoided. Avoid
ultra-high-speed engine work.
Note: When traveling to the 300 km 500km, the oil must be
replaced.
As the car had not been installed Odometer to estimate mileage
can only be calculated
Summary of Contents for ATV-3050C
Page 21: ...P40 P41...