ASSEMBLY GUIDE
STEP 1
Take all parts out of the box to ensure they are present.
(a)
Umbrella with frame canopy
(b)
Cover
a
b
3m
Pole Diameter: 48mm
3m
2.4m
STEP 2 - TO OPERATE
STEP 3
STEP 4
STEP 5
STEP 6 - STORAGE
When not in use, close the umbrella,
place the umbrella cover over it and
store in a dry place.
WARNING
When assembling and using this product, safety precautions should always be followed to reduce
the risk of personal injury and damage to equipment.
Please read all instructions before assembly and use.
Install on level ground.
A suitable umbrella base is required (not included) to prevent tipping.
This is a non-permanent structure, do not use in extreme weather conditions including heavy rain
or high winds.
Do not leave the umbrella open unattended.
The diagrams in this manual are for assembly and operation illustration only.
CARE AND MAINTENANCE
If the canopy is wet, allow to dry naturally in the open position before
storing. If necessary, clean the fabric with a hose.
Components subject to turning and sliding can be treated with a
non-staining lubricant spray (silicon-based).
Secure pole into a suitable umbrella
base (not included). Pull rope down
to open canopy.
Whilst holding rope, insert pin
through the slot on the pole
Wrap excess rope around rope cleat.
To take umbrella down, unwind rope
from cleat, hold rope tightly and
remove pin. Slowly release rope until
canopy is closed.
