Cool Space CS5-16 Series, Operation & Maintenance Manual

Page: 8 / 24

6
1. Use a wrench to remove the (2) bolts connecting the pad retainer (pad side) to the
housing.
2. Each pad can be tilted out of the unit and lifted out of the drain tray.
Note: Reinstall pads correctly.
5.2 Daily maintenance:
When shutting down the COOL-SPACE ® unit at the end of each workday, the pump
should be turned off approximately 15 minutes before the fan is turned off. This will
allow the pads to drain and dry out. This simple guideline will ensure long and efficient
pad life as well as help to control mildew and bacteria growth.
IMPORTANT
Shut off pump 15 minutes before shutting off fan to allow pads to drain and dry out. This
will help pad life and operation and control mildew growth.
5.3 Periodic maintenance:
Depending on how often the COOL-SPACE ® unit operates, this procedure should be
performed anywhere from every week for heavy use to monthly for light use. Shut down
the unit and drain the water sump. The cooling pads act as a filtering agent and remove
dust and other particles from the incoming air stream. These particles will flow into the
sump and collect there. Also, impurities in the water will collect in the sump.
1. Close the water flow valve and open the drain valve.
2. Run pump until sump is dry then immediately shut off pump.
3. Turn unit off and disconnect power supply.
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect the power supply before performing any service or
maintenance on the unit. Failure to do so may result in serious injury or
death.
4. Remove cooling pads, refer to 5.1.1.
5. Clean out reservoir with either a towel or wet/dry vacuum.
6. Check belt for tightness, if applicable.
7. Remove the water spray bar, remove its plug. Using pump flush tube and insure
holes are free of debris.
8. Reinstall pads and pad retainer.
9. Reinstall back guard (if applicable).
To keep the COOL-SPACE
®
unit operating at peak efficiency, ensure that the cooling
pads are kept clean and dust-free. Dust and other particles have an adverse effect on the
media’s ability to introduce water into the air stream. If the pad surface becomes dirty or
dusty, clean with a soft brush and water.
The fan motor may require periodic lubrication depending on the COOL-SPACE
®
model. Check your model for an oil fill location on the motor. A few drops of light oil
each year will extend motor life.