Cool Machines 1500 Series, Owner'S Manual

Page: 6 / 49

Rev. 12/8/2017 Page 6
Un-Packing and set-up of machine:
Machine Specifications:
Weight
: Airlock: Blower/ Sizes:
CM-1500 (single blower) 310lbs. 10
” x 10” diameter (Before S#:CM-0723 ) one or two large blowers
CM-1500 (double blower) 330lbs.
10” x 14” diameter (S#:CM-0723 -Present) one big & one small
3” output for hose
Dimensions: Power Requirements: Generator:
24
” W x 37” L x 57” H
Double input, 15 amp. 120 volt. 1-blower/ 5,000 watt
2 large blowers = 15 amp and 2-blower/ 7,500 watt
Hopper Capacity:
20 amp 120 volt inputs
14 cu. /ft.
What should be enclosed with your standard machine?
Machine should have a 150 ft. remote cord included inside hopper that needs to be removed and
placed on handle/cord hanger, located on control panel end of machine. All other parts and
accessories will be packaged separately and placed inside hopper for shipping.
Available Options: Wheel Assemblies, Wireless remote, Blowers (1, or 2), Internal Wetting System,
along with a complete line of hoses, fittings, couplers, hose reels, and accessories. See accessory
literature for additional offerings.
Moving and lifting machine:
(Note: hopper/control panel assembly must be detached before attempting to manually lift), otherwise
an auxiliary lifting device is needed to move this machine. The machine is designed with large flip-up
handles for convenient lifting by two people after hopper has been removed. (one on each side of
base unit). Caution: personnel with lifting restrictions should use mechanical lifting devices. The
wheel assembly is recommended for frequent moving of machine without mechanical assistance.
Locating machine in vehicle:
M
achine is designed to be located on the driver’s side, rear of the vehicle. Hook-up of blowing hose
and controls are easily reached from rear of vehicle while allowing for easy adjustment and control of
machine. This provides quick access to machine service points.
Power Supply:
Depending on quantity and size of blowers, the machine will require two (2) inputs. 15 amp. and
15/20 amp.120 volt or (2 -10 amp. inputs, 240 volt, overseas) single phase power supply. If generator
is used, a 5kw (or larger depending on quantity and size of blowers), is recommended for ample
power supply. Note: providing good source of power with oversize generators & extension cords, (not
exceeding 100 ft./35 meters), will assure longevity of motors and electrical components.
Machine is shipped with short input cord(s), and connected to a male input plug(s). (except overseas
units). Consult a qualified electrician for proper recommendations on power cable size.
Machine Set-up:
After securing the machine in vehicle and hook-up of power supply has been completed, the machine
is ready for hook-up to blowing hose and remote control cord. Make sure all hose connections are
securely fastened. (Consult factory for alternative floor plan layouts of machine and equipment in
vehicle.