4
SPeCIfICATIONS ANd INSTALLATION
Installation: drop-in
Install or locate this equipment only in accordance with
the instructions below.
Unpacking Instructions
1. Remove the SinAqua™ Souper™, mounting ring,
and control box from the packaging.
2. Before throwing the packaging away, check it
thoroughly for accessories and literature.
3.
Make sure the power cord is firmly attached
before plugging the unit into the power
receptacle and before attempting operation.
NOTE: Keeping the packaging is recommended in
case the equipment needs to be transported.
It is the responsibility of the installer to comply with
all federal, state, and local codes. Any installation not
matching the specifications discussed in this manual
automatically voids the product warranty.
Installing the Souper™ and Control Box
1. Connect the Micro USB cable to the Souper unit
(Figure 5, below).
2. Install the Souper™ using the following surface
cutout dimensions:
- 7 Qt Souper™: 12-inch (305 mm) diameter hole
- 11 Qt. Souper™: 14-inch (356 mm) diameter hole
3. Install the stainless steel overlay, if the accessory
was ordered (Figure 6, below).
4. Connect the other end of the Micro USB cable to
the control box (Figure 7, page 5) and install the
control box using the cutout dimensions in
Figure 8 (page 5).
5. Plug in the Souper™ to the power source.
CAUTION: The SinAqua™ Souper™ is designed to
operate without water and does not employ steam
to heat food. If water is allowed to enter the
chamber wherein the tureen is placed, whether by
way of operational error or for cleaning purposes,
the water will drain below the Souper™ unit (see
Figure 5, below). When installing the drop-in
Souper™ unit, plan accordingly.
figure 5: Micro USB Connector
Connect Micro
USB cable here
figure 6: Install the Stainless Steel Overlay Accessory
STAINLESS
BEAUTY RING
Stainlesss Steel Overlay
(accessory only; not
standard item)
If water enters the chamber,
it will drain here
Summary of Contents for SAS081-11
Page 4: ......
