Assembly Instructions…
Step 9 – Lid Handle (part #8)
Hardware: M6 large wing nuts (part #21) – 2 pcs
flat washers (part #23) – 2 pcs
lock washers (part #22) – 2 pcs
Locate the Lid Handle and remove the cardboard from the
Handle screws, careful not to let the short tube and washer
come off, Set aside two (2) M6 large wing nuts, two (2) flat
washers, and two (2) lock washers. With the Lid open, place
the screw ends of the Lid Handle (with short tube and washer)
through the holes on the outside of the Lid as shown here.
From inside the Lid, place a flat washer and lock washer on
each screw and affix using the large wing nuts.
Step 10 – Heat Reflector Plate (part #4) and Heating Element (part #5)
Hardware: M5*12 small screws (part #17) – 2 pcs
M5 small wing nuts (part #20) – 2 pcs
flat washers (part #23) – 2 pcs
lock washers (part #22) - 2 pcs
Locate the Heat Reflector Plate and the Heating Element.
Set aside two (2) M5*12 small screws, two (2) M5 small
wing nuts, two (2) flat washers, and two (2) lock washers.
Place the Heat Reflector Plate into the Bowl with the
metal bands facing up and parallel to the front of the
Grill, as shown below. Then, place the Heating Element
on top of the Heat Reflector Plate. Make sure the ‘Top’
of the Heating Element box is facing up and fits through
the rectangular hole at the front center of the Bowl.
Insert the small screws from outside the Bowl through
the holes on each side of the Heating Element box. From
inside the Bowl, place a flat washer then lock washer on
each screw and affix the Heating Element to the Bowl
using the small wing nuts. See Step 11 for final
placement of Heating components.
10
