GB
• The nominal heat input is correct when the appliance is fitted with the appropriate supply voltage is as specified in Table
T1.
Checking the nominal heat input
Switch on the appliance in accordance with the instructions for use and check the control devices and heating elements.
Checking the electrical system
• Connect each system (PA) all electrical equipment installed
• Connect the equipment into an effectively earthed.
Earth and equipotential connection
TURNING ON THE APPLIANCE
• Make sure the power terminal block of appliance is connected to a separate duly rated power line (see the “Technical
data” table).
• The appliance is designed to operate at the voltage indicated on the rating plate.
Electrical connections
• The appliance must be fitted with homopolar safety cut-out switches of suitable capacity with a contact breaking distance
of at least 3 mm, and highly sensitive differential protection device. The maximum leakage current is 1 mA/kW.
• The power supply cable must be flexible and of a type matching at least the qualities of a rubber-type cable H 07 RN-F.
• Carefully remove the protective film from the external panels to avoid leaving any trace of glue. Use a suitable diluent to
remove any glue residue.
Installation
• This distance may be reduced if the walls are flameproof or protected by insulating material.
• Place the appliances side by side and adjust to the same height.
Joining tables together in line
• Set the appliance level by means of the adjustable feet.
The manufacturer declines all responsibility for failure to comply with this requirement.
• Position the appliance at least 10 cm from surrounding walls.
• The overall dimensions/connections and technical data are shown on the corresponding pages in the appendix.
Positioning
INSTALLATION
Appliances are in accordance with the EEC Directive 89/336 on the electromangetic compatibility.
CONFORMITY TO REGULATIONS AND LAWS
WARNINGS
Installation and maintenance of the appliance and its conversion to a different gas supply must only be performed by a
qualified installer authorised by the manufacturer in compliance with current safety standards.
INSTALLATION INSTRUCTIONS
GRX 1
14 / 33