11
In
more
detail...
GB IE
Operation
Caution
•
If there is no electric current you can light the burners with
piezo electric spark gas ignitor.
•
The burners can only be lit with safety thermocouples when
the knob is on
MAXIMUM.
fig. 4
fig. 5
Operation
Use of the burners
On the control panel (fig. 4) to the right every knob there is a diagram to
indicate the burner to which the knob in question refers. The burners can
be switched on in several ways, according to the type of appliance and its
individual features.
> manual “ON” switch (this is always possible
even if the electric current is off):
• Turn the knob (fig. 5) corresponding to the
selected burner in a counter-clockwise
direction so that the knob is at maXImUm
(this corresponds to a large flame).
•
Use a piezo electric spark gas ignitor.
> automatic electric “ON” switch for burners with safety device
(thermocouples):
• Turn the knob (fig. 5) corresponding to the selected burner in a
counter-clockwise direction so that the knob is at maXImUm.
•
Once the burner is lit, keep the knob pressed in for about 10 seconds
in order to allow the flame to heat up the thermocouple. If the burner
goes out when the knob is let go, repeat the operation.
