Conviron GEN1000-GE, Operator'S Manual

Page: 40 / 54

GEN1000-GE Operator Manual
32 November 8 2019 | 291180-ENG R00
5. Align the slots on the top end cap with the fixture (Figure 6-10) and press the top end
cap into the tube.
6. Tighten the top end cap screws (Figure 6-11).
Figure 6-10 Align the End Cap with the Fixture Figure 6-11 Tighten the End Cap Screws
7. Insert the lamp fixture assembly back into the clamp on the wall or door (Figure 6-12).
8. Secure the fixture in place with the brackets (Figure 6-13).
9. Reconnect the power cable (Figure 6-14).
Figure 6-12 Install the
Fixture
Figure 6-13 Install the Brackets Figure 6-14 Connect the
Power
10. Turn on power to the chamber and test the light.
6.4 Calibrating the Temperature and Humidity Sensor
Conviron recommends that the temperature and humidity sensors be calibrated yearly. Contact
Conviron Service for more information.