Remote Control
1.
Power-
This is the power on and off button.
2.
Display-
This button allows you to enable or disable the on screen display of the
resolution information.
3.
C-Video-
Press the button to select composite video as input source.
4.
S-Video-
Press the button to select S-Video as input source.
5.
YCbCr-
Press this button to select YCbCr as the input source.
6.
PC-
Press the button to select PC input looping through to the output.
7.
VGA-
Press this button to select 640 x 480 as output resolution.
8.
SVGA-
Press this button to select 800 x 600 as output resolution.
9.
XGA-
Press this button to select 1024 x 768 as output resolution.
10.
SXGA-
Press this button to select 1280 x 1024 as output resolution.
11.
480p-
Press this button to select 852 x 480p as output resolution.
12.
576p-
Press this button to select 852 x 576p as output resolution.
13.
720p-
Press this button to select 1280 x 720p as output resolution
14.
1080i-
press this button to select 1920 x 1080i (interlaced) as output resolution.
15.
Aspect Ratio-
Press the button to switch between standard (4:3) and wide (16:9)
aspect ratio.
16.
IR-Set-
When the front panel is locked out; press this button for over 15 seconds
and it will lift the lockout.
17.
3D-
Press to turn on or off the 3D enhance.
18.
NR-
Press this button to turn on or off the digital noise reduction.
19.
Mode-
Press this button to toggle through the following adjustments: Source-
Resolution-Output-Aspect-3D Enhance-Digital NR.
20.
Picture-
Press this button to toggle through the following picture adjustments:
Contrast- Bright- Colour- Tint- Sharpness.
21.
Reset-
Press this button and it will revert picture adjust back to factory preset
values.
Connection and Installation
The AC adaptor power unit should not be plugged into a wall outlet until all connections
are complete.
-
Connect your Video or DVD device using the appropriate connector cable to the
Composite Video (Number 1 on rear panel), S-Video (Number 2 on rear panel) or
YCbCr input port (Number 3 on rear panel).
-
Connect your PC, Notebook or MAC to the PC In port (Number 4 on rear panel).
-
Connect your projector or HDTV to the RGB/YPbPr Output port (Number 5 on the
rear panel). The HD-15 D-Sub connector is shared by PC/RGBHV output and
HDTV/YPbPr output. When PC/RGBHV output resolution is selected, use the HD-
15-to-HD-15 VGA cable to connect the output to the PC input of your display
monitor. When HDTV/YPbPr output is selected, use the HD-15 to YPbPr 3 x RCA
cable to connect the output to the YPbPr input of you HDTV display.
Please browse our online catalogue to view our full product range.
44-48 Maitland Road, Mayfield East, NSW, 2304 Australia,
Phone +61 249689313 Fax +61 249689314
www.converters.tv
