11.
6
OVERHEAT CONTROL
This heater is equipped with separate overheat controls for the convection element
and for the fan-forced system. In case of a malfunction of the unit (blocked air output or
intake), the heater will stop heating automatically. After correcting the malfunction the
heater can be reset.
To reset the heater :
-
Convection element
: Check that the front panel, top and bottom of the heater are free
of obstruction. Once the obstruction is removed and the heater cools down, the overheat
control will reset automatically.
-
Fan-forced system
: Verify that the air inlet and outlet are not obstructed. After 5
minutes, put the heater back on by reseting the panel's breaker.
7
MAINTENANCE
To keep your CONVECTAIR unit clean, regular maintenance is suggested. To remove
dust, use a soft cloth. To remove a stain, use a damp cloth.
For a better performance and maximum efficiency, it is suggested that dust and lint be
regularly removed from the protective grill situated in front of your SAMBA II.
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS TO CLEAN YOUR
HEATER AS THIS MAY DETERIORATE THE EPOXY FINISH.
ANY REPAIR ON YOUR CONVECTAIR HEATER SHOULD ONLY BE DONE
BY A QUALIFIED TECHNICIAN, AND ONLY AFTER HEATER HAS BEEN
DISCONNECTED.
Recommendations and advice
Your CONVECTAIR heater will become hot when in use. Caution is advised when young children are
present.
Do not insert small objects in the heater : this could cause an electrical short circuit, fire or damage to the
inner components.
Any use or modifications not approved by CONVECTAIR may cause electrical short circuits, fire or injuries
to the users.
In certain cases, it is possible for yellowing of the surface to occur over time. This is not due to a
manufacturing defect.This is caused by surrounding air, which may contain smoke or dust, being heated
and circulated through the heater. This is particularly the case with white heaters and may translate in an
important important coloring of the unit.
Prevention : it is suggested that surfaces be frequently cleaned especially with units installed in
bathrooms, kitchens, locations where cigarette smoke is present, rooms with a fireplace or wood
stove. Never use this heater during construction work or other activities that generate a lot of dust.
