OWNER’S MANUAL
|
The heater has a temperature sensor.
When the room temperature reaches the set
temperature, the heater will automatically
switch to standby mode. Once the room
temperature has cooled by 2°C the heater
will automatically turn ON. The heater will not
judge the temperature within 10s of the heater
turning on.
To set a desired temperature:
1. Press the SET button twice to enter into
temperature setting mode. The temperature/
timer setting light will fl ash on the display
panel.
2. Press UP and DOWN to set the desired
temperature. Pressing the UP and DOWN
buttons will increase and decrease the
temperature by 1°C increments. Temperature
set range is 15°C to 35°C.
3. Press the SET button to quit the temperature
setting mode or wait 4 seconds. The room
temperature will be displayed.
4. Reset the temperature by re-entering the
temperature setting mode and using the UP
TEMPERATURE SETTING MODE
Make sure that the device is switched off
before cleaning.
Wipe the surface of the heater by using a clean
damp cloth.
Do not use chemical liquids when cleaning
the heater.
Do not submerge the heater in water.
Make sure that the heater has cooled down
completely before storing. Storing in its original
packaging is highly recommended.
CLEANING AND STORING
OPERATION CONT.
4
Waste electrical products must not be disposed of with household waste.
This product should be taken to your local recycling centre for safe treatment.