CERAMIC TOWER FAN HEATER - CTH05
|
3
OPERATION
1. Press Power switch on the back of the
heater, to begin use. The heater will make a
‘beep’ and enter into standby mode.
2. Press the ON/OFF button turn ON the
heater.
SET. Press once to enter into timer
setting mode, and twice to enter into
temperature setting mode.
UP. Press to increase temperature/
timer setting.
DOWN. Press to decrease
temperature / timer setting.
BUTTON LIST CONT.
OPERATION
1. Press the SET button once to enter into
timer setting mode. The temperature / timer
setting light will fl ash on the display panel.
2. Press the UP and DOWN buttons to set the
time before the heater automatically enters
standby mode. Pressing UP and DOWN
will increase and decrease the time by 1 hr
increments. Timer range is 1-12hrs.
3. If there is no operation of the buttons after
4 seconds the timer will be set. The display
will now cycle between the current room
temperature and the timer countdown.
4. Reset the timer by re-entering the timer
setting mode and using UP and DOWN to
set a desired time.
5. To cancel the timer setting, set the timer to
zero hours
TIMER SETTING MODE
ON/OFF. Press to switch between
standby and ON modes
POWER. Press to shift between low
(1100W) and high (2000W) heating
power
OSCILLATION. Press to make the
heater rotate from side to side. Heater
has an 80° oscillation angle.
BUTTON LIST
CONTROL
4
DISPLAY
1. ON/OFF indicator light
2. Power setting.
3. Temperature / timer setting
4. Oscillation mode indicator light
5. Timer indicator light
3
Controls and operation for both remote control
and control panel are identical.
