Convair CMH01B, Owner'S Manual

Page: 6 / 12

®
4 SEELEY INTERNATIONAL
–
OWNER ’ S MANUAL 5 CMH Series Portable Heater
OPERATION cont. MAINTENANCE
• Pressing the “ + UP ” and “ - DOWN ”
buttons to adjust the set time by 1 hr
increments up to 23 hrs. You can
change the time remaining at any point
repeating the above steps.
• Leave at the desired time. The
heater ’ s display will alternate between
showing the TIME REMAINING and the
ROOM TEMP every 10 seconds. The
timer will begin to count down until the
heater turns itself off.
• To cancel the timer, set the time to
“ 00 ” .
To maximise the efficiency of the heater,
clean the inlet and outlet grilles
regularly.
• Unplug the heater from the mains
power supply before cleaning.
• Use a soft, damp cloth to wipe the
outside. Never use thinners or other
strong chemicals on the heater
surfaces.
• Use a vacuum cleaner to remove dirt
and dust from the front grille & back
panel vent slots.
• Ensure the heater is dry before
plugging back into the mains power
supply.
• Press the “ POWER ” button on the
unit or the remote control to change the
temperature from LOW (2 bars), MED(4
bars) or HIGH (6 bars).
• Turn the heater OFF by pressing the
“ ON/OFF ” button at any time.
Your heater will operate most efficiently
when utilising the thermostat to turn
your heater off when your desired heat
setting is reached. To operate your
thermostat:
• Press the “ SETTING ” button on the
unit or “ SET ” button on the remote
control TWICE. The current setting will
flash (eg 25°C)
• Select the temperature setting you
want by using “ + UP ” and “ - DOWN ”
buttons on the unit or remote. You can
select in the range of 15°-35°C.
• When the room temperature is
below the selected set temperature, the
unit will heat the room. If the room is
above the set temperature, the heat
element will turn off.
Do not set the thermostat
temperature too high. This will
consume more power. 23°C is the
recommended set temperature.
The TIMER function can be used to turn
the heater OFF automatically.
• Press the “ SETTING ” button on the
unit or “ SET ” button on the remote
control.
“ 00 H ” will appear on the timer display.
To use the THERMOSTAT:-
Tip !
To use the TIMER function:-
OPERATION
REMOTE CONTROL
POWER
ON/OFF
TIMER/
THERMOSTAT
ADJUST
POWER
SETTING
ADJUST
TIMER/
THERMOSTAT
ADJUST
Turning the power on
• Insert the plug into the power outlet.
• Turn the power switch located near
the power cord to “ ON ” . The heater will
“ beep ” and the POWER INDICATOR
light on the control panel will illuminate.
• Remove the battery cover and install
the button type battery supplied.
• When the heater ’ s power is on, the
remote control can be used to operate
the heater from up to 6m away.
Note: if there are two or more heaters
within this distance, both will be
operated by the same remote control.
• Turn the heater ON by pressing the
“ ON/OFF ” button on the unit or the
remote control (see Fig 2 & 3). The
room temperature will be displayed on
the LCD display (Fig 2).
Remote control setup
Heater functions
3