Remote-i Net
Installation
The installation of
Remote-i Net
is very simple, and it comes configured by the manufacturer to operate
on the majority of local networks without any additional configuration being required.
Prior to starting the installation, verify that the location where the
Remote-i Net
will be installed fulfills
the requirements necessary for physical connection:
y
electrical AC socket supplying 110 or 220V
y
local network access point
The power source provided with the
Remote-i Net
leaves the factory set to 220V. Verify that the voltage
available at the socket is correct. If not, move the selection switch
to the correct voltage (220 or 110).
The physical
Remote-i Net
connections will be made at the back of the equipment, as shown in the
following figure:
2
Contronics
Figure 1 - Back of Remote-i Net.
