©2014 Control4. All rights reserved. Control4, the Control4 logo, the Control4 iQ logo and the Control4 certified logo are registered trademarks or trademarks of Control4 Corporation in
the United States and/or other countries. All other names and brands may be claimed as the property of their respective owners. 200-00240, Rev. E 03/21/2014 (BN)
control4.com |
™
3
While pressing and holding the
Factory Restore
button, power on the HC-250.
4
Hold the button until the WiFi Status LED blinks
Orange. This should take five (5) to seven (7)
seconds. The Status LED will blink Orange while
the restore is running.
Factory Resets
• Press the
Factory Restore
button, but do not
hold it down. The controller will reset.
Identification Button (Network Reset)
To reset the HC-250 network settings to the default,
perform the following steps:
1
Disconnect power to the HC-250.
2
While pressing and holding the
ID
button on the
back of the HC-250, power on the HC-250.
3
Hold the
ID
button until the Data, Link and Power
LEDs are solid Blue, then immediately release the
button.
4
If during the boot sequence the Status LED stays
Orange, press and hold the
ID
button until the
LED blinks Blue, and then release it.
Regulatory/Safety Information
To review regulatory information for your particular
Control4 products, see the information located on
the Control4 website at: http://www.control4.com/
regulatory/.
Warranty
Go to http://www.control4.com/warranty for details.
6
