™
Warnings and Considerations
WARNING!
The Bus Power Supply should be installed by a licensed
electrician in accordance with all national and local electrical codes.
ATTENTION!
Le bus d’alimentation doit être installé par un électricien
certifié conformément à tous les codes électriques nationaux et locaux.
WARNING!
Improper use or installation can cause SERIOUS INJURY,
DEATH or LOSS/DAMAGE OF PROPERTY.
ATTENTION!
Une mauvaise utilisation ou installation peut entraîner des
blessures graves, décès ou perte / dommages à la propriété.
WARNING!
This device must be protected by a circuit breaker (20A max).
ATTENTION!
Cet appareil doit étre protègè par un disjoncteur (20A max.)
IMPORTANT!
Use this device only with copper or copper-clad wire. Do
not use aluminum wiring. This product has not been approved for use with
aluminum wiring.
IMPORTANT!
Using this product in a mannner other than outlined in this
document voids your warranty. Further, Control4 is NOT liable for any
damage incurred with the misuse of this product. See “Troubleshooting.”
IMPORTANT!
This is an electronic device with intricate components.
Handle and install with care!
Front View
Figure 1. Front View
A
Line Voltage Connector
B
Low Voltage Connector
C Bendable
Tab
D Mounting
Bracket
Supported Model
đŏ
C4-BPS48 Bus Power Supply, 48V
Introduction
The Control4® Bus Power Supply, 48V is intended for use in a Control4 system and
installs in a Control4 Panelized Lighting panel. The Bus Power Supply provides the
power to the Bus Ethernet Gateway and Control4 Configurable Wired Keypads.
Box Contents
đŏ
Bus Power Supply
đŏ
Bus Power Supply Mounting Bracket
đŏ
Warranty Card
đŏ
One (1) Ferrite Clamp
đŏ
Two (2) Mounting Screws
đŏ 1/ŏ+3!.ŏ1,,(5Čŏąĉŏ */0((0%+*ŏ1% !ŏ
(this document)
Specifications
Model Number
C4-BPS48
Power Input
100-240VAC, 50/60Hz
Power Output
48VDC
Power Consumption
100-240VAC at 1.8A
48VDC at 1.8A (or 86.4W)
Connectors
One (1) Line Voltage Screw
Terminal one (1) Line, one (1)
Neutral, one (1) Earth Ground
One (1) low-voltage screw
terminal; two (2) 0V, two (2) 48V
Environmental
Operational Temperature
32˚F to 104˚F (0˚C to 40˚C)
Humidity
5% - 95%
Non-condensing
Storage
-4˚ F - 158˚ F
(-20˚ C - 70˚ C)
Dimensions and Weight
H x W x D
5.5” x 9.75” x 7.75” (139.7mm x
247.65mm x 196.85mm)
Weight
2.3 lbs. (1.04 kg)
Shipping Weight
2.85 lbs. (1.28 kg)
Bus Power
Supply, 48V
Installation Guide
B
A
D
C
