4
Back Panel: Power Cluster
A
Power Plug Port—For use with a standard IEC
equipment power cord. Use the supplied power
cord or ensure the power cord you are using is at
least 18 AWG or larger.
B
Fuse—Replace only with 6.3A 250V fuse
.
C
POWER switch
D
Trigger Input / Output Controls
E
ON/OFF TRIGGER
Install the Amplifier
This device operates as part of the Control4 home
system which requires physical connections to
function as designed. This section describes how
to set up the physical connections required for the
amplifier and all of the devices associated with it.
CAUTION!
To prevent damage, maintain
adequate ventilation space above and below
the amplifier. Space of
½
U on top and bottom
is adequate. The rack mount ears provide the
necessary
½
U ventilation space.
Do not place
other components on top of the amplifier.
Doing so will block ventilation openings.
ATTENTION !
Pour éviter tout dommage,
maintenir un espace de ventilation adéquate
au-dessus et en dessous de l’amplificateur.
Espace de
½
U sur le dessus et le bas est
adéquate. La monture oreilles pour rack
fournissent des
½
U d’espace de ventilation.
Ne
placez pas d’autres éléments sur le dessus de
l’amplificateur.
Ceci bloquerait les ouvertures
de la ventilation.
A
B
C
D
E
WARNING!
Connecting speaker wires or input
cables while the amplifier is powered may
cause electrical shock and could damage
the amplifier. Unplug the power cord before
making connections.
AVERTISSEMENT !
Les fils se reliants de
haut-parleur ou les câbles entrés tandis
que l’amplificateur est actionné, peuvent
causer le choc et pourraient endommager
l’amplificateur. Débranchez le cordon de
secteur avant d’établir des rapports.
1
Connect up to four (4) (4-Zone Power Amplifier)
or up to eight (8) (8-Zone Power Amplifier)
audio sources to the audio input jacks. You can
also connect an additional audio source to the
GLOBAL input jacks.
2
Connect speakers to the Phoenix-style
connectors.
CAUTION!
Check the polarity of the
speakers and wires before connecting to
the amplifier.
ATTENTION !
Vérifiez la polarité des
enceintes et des câbles avant de brancher
à l’amplificateur.
3
Set the individual Zone Input settings. Select
Line
In
or
Global In
depending on system setup. If
zone is configured for a bridge, see “Setting Up
Bridge Mode” below.
4
Connect the power cord provided to the back of
the amplifier and to the power outlet.
5
Press the top of the POWER switch to turn on
the amplifier. The amplifier powers on.
Setting Up Stereo Mode
In Stereo mode, connect the L and R channels as
usual.
1
In the zone you are connecting speakers to, slide
the
ST/BRIDGE
switch to
ST
.
2
Connect the audio source’s
L
channel to the
LINE
INPUT
(
L
) jack and the
R
channel to the
LINE
INPUT
(
R
) jack.
