Contrec 102D, Manual

Page: 19 / 32

Programming 15
MAN102D-V1.8
CAL 18 Enabling and number of points for linearisation
’00’ = Linearity Disabled; ‘02’ – ‘10’ number of points
If linearity is enabled by entering a number 02-10, then the
programming will request data as per the table below.
Input points are entered in ascending order.
INP 01 Input Frequency ‘01’ whole number
INP ...00 Input Frequency ‘01’ digits after decimal point
OUT 01 Scaling Factor ‘01’ whole number
OUT . 00…Scaling Factor ‘01’ digits after decimal point
Repeat the above for the remaining scaling factors.
Any frequency greater than that of the last linearity point will be
scaled at the last scaling factor.
SOFT Software Version.