Continental Refrigerator XT 1.0, Original Instructions Manual

Page: 11 / 16

11 Contononta netin Synne DI PLAY
5.2 Uyn: htogtog ynnntogy
5.2.1 wtnchtog Co nhn dtypatS
» Press and hold the button for 1 second to
switch on the CeBS.
5.2.2 nancntog nhn dtypatS vtnw
You can select the display view in the set-up menu
(
see document REMOTE).
1. Press and hold the button for approx. 3
seconds to open the set-up menu.
2. Briefly press the button several times to
open the VIEW menu item.
3. Use the / buttons or the joystick to
select the desired view.
4. Press and hold the button for 3 seconds to
exit the set-up menu.
5.2.3 htogtog nhn nrtp dtnt dtypatS
(oCreta vtnw)
» Briefly press the button several times if
necessary to switch to the desired trip data
display in the normal view.
Trip data
display Content
Time display
TRP-TIME
= trip time in minutes
CLK
= current time (HH:MM)
Power output
display
RPM
= cadence (revolutions/
minute)
PWR
= rider performance in watt
Range
display
RANGE
= estimated range remaining
at current charge level
BAT
= current battery charge
level in %
Trip display
TRIP
= daily trip reading in km
The daily trip reading can
be reset by pressing and
holding the light button for
approx. 3 seconds.
ODO
= total trip reading in km
Trip data
display Content
Speed sensor
AVG
= average speed in km/h
MAX
= current maximum speed in
km/h
Select
MANUAL
or
AUTOMATIC
gear-change
mode
(only in
combination
with the 48 V
Revolution
drive unit)
MANUAL
= manual gear-change mode
In manual gear-change
mode, you can select the shift
settings manually (GEAR).
AUTOMATIC
= automatic gear-change
mode
In automatic gear-change
mode, you can select your
own personal cadence setting
(RPM).
The cadence can be adjusted
to a setting between 20 and
120 rpm in increments of 1.
NOTE: If your eBike is fitted with a 48 V Revolu-
tion drive unit, you can use an additional function:
1. Press and hold the button or push the
joystick forwards for approx. 3 seconds to
access the MANUAL or AUTOMATIC menu
item directly.
You can then configure the settings for the
relevant gear-change mode directly.
2. Press and hold the button for approx. 3
seconds to change the gear-change mode.
3. Briefly press the button once to confirm the
selection and return to the normal view.
NOTE:
To reset all temporary values, press and
hold the light button ( /
/ button) in the
normal view for a minimum of 4 seconds.