2
5
. Insert your CAT5/6 Ethernet cable first
through a cable clamp (Fig. 5) and then
through a knockout located on the left side
of the panel enclosure. Pull only enough
of the Ethernet cable into the enclosure to
allow the plug to be easily inserted into
the Ethernet board receptacle.
6
. In the parts bag, find the silver braided shield. For FCC com-
pliance, this braided shield must be both secured to the cable
clamp and placed over the Ethernet cable in the interior of the
panel enclosure.
Note:
The presence of this silver braided shield makes
shielded twisted pair (STP) cable unnecessary. In addition,
unshielded twisted pair (UTP) cable does not need to be
routed in conduit.
Before tightening the cable
clamp, place the braided shield
over the Ethernet cable.
Pull the
braided shield out through the
panel knockout and into the cable
clamp
. Thus, the braided shield
is grounded to the panel enclo-
sure by the cable clamp (as
shown in Fig. 6.
7
. The Ethernet cable
must
be covered by the braided shield but
leave about one inch of cable exposed near the
plug. Note that this one inch of exposed cable
should be measured with the Ethernet cable
plugged into the Ethernet board receptacle. If
desired, use electrical tape to cover the end of the
braided shield as shown in Fig. 7, below.
DO NOT cover the plug with the braided shield
.
Be sure to tighten the cable clamp screws securing both the
Ethernet cable and the braided shield to the panel enclosure.
8
. Plug the Ethernet cable into the Ethernet board receptacle.
9
. Re-connect power from the main Superterm PCB by pushing
the POWER plug connector on the lower right of the PCB
upward into the PCB. Verify that the OK lamp (LED) on the
Accelerator board blinks on and off once per second. Also
verify the heartbeat lamp on the motherboard (location T1)
blinks in unison with the OK lamp on the Accelerator board.
Note:
The status LEDs on the top of the Ethernet board re-
ceptacle will blink when network activity is detected (see im-
age in Fig. 8 for the location of these status LEDs).
Note:
On the CICP2800PMBD Base Processor PC board,
be sure the MEMORY BACKUP CELL jumper is in the IN
position to provide memory data retention. See Fig. 9 and
WI2044 for complete installation instructions for the
CICP2800PMBD.
Fig. 5: Cable
Clamp
CL
R
OU
T
IN
Fig. 9: "IN" Position
Status LED's
Fig. 8: Location of status LED's. These LED's
will blink when network activity is detected.
Fig. 6: PANEL EXTERIOR:
Both the Ethernet cable and
the braided shield must be
grounded to the panel enclo-
sure by the cable clamp.
Fig. 7: PANEL INTERIOR: Leave one inch exposed as shown (if desired,
use electrical tape to cover the end of the braided shield).
DO NOT cover
the plug with the braided shield
.
1 inc
h
