Edition 11/2016 - CG200 OD
SACOME, Document CONFIDENTIEL,
Ne peut être reproduit ni communiqué sans notre accord préalable.
- 15 -
4. UNPACKING AND INSTALLATION:
Warning: All appliances’ technical handling operations such as installation, maintenance, or service should
be performed by certified personnel or by your local dealer.
•
After opening the box, make sure that the appliance is intact and that there is no visible
damage. If there is any doubt, DO NOT use the appliance and call your local dealer for further
assistance.
•
Unpack the carton box carefully. For your convenience we suggest storing all packaging
materials where they can be used in the future, whenever the appliance’s transportation is
necessary.
•
Place the grinder on a stable flat counter in a dry area away from water or water splashes.
•
Position the coffee residue tray underneath the body in front of the appliance.
•
Install the beans hopper firmly on top of the body inside the top blade holder.
•
Fasten the hopper to the appliance body by means of the supplied screw. (fig.4.1) Make sure that
the screw is inserted completely through both holes in the hopper and in the top blade holder.
Fig.4.1
•
NEVER OPERATE THE GRINDER IF THE BEAN HOPPER IS NOT FULLY SECURED IN ITS
POSITION.
•
Before plugging in the electrical cord, make sure:
o
The appliance voltage and frequency rating (according to the back side label) is the
same as the supply mains.
o
The wall socket is fitted with an efficient ground contact. DO NOT plug the appliance into
the supply mains if the ground system was not positively checked to be in compliance with
current safety rules. IT IS COMPULSORY TO GROUND THE APPLIANCE. The
manufacturer cannot be held responsible in the event that this regulation is not complied
with.
o
The power consumption of the appliance (according to the backside label) is
consistent with the relevant wall socket capacity.
o
The wall socket is protected against short outs and power surges.
o
Do not use extension cables, plug adapters for multiple sockets, or make shift connections.
•
Plug in the appliance.
•
Upon first time operation, and before placing beans in to the hopper, VISUALLY check that the
blade rotation direction is clockwise by switching the appliance ON for a few seconds.
•
Should the rotation direction be wrong, do not use the appliance and contact your local dealer
for further instructions.
Summary of Contents for CG-200 OD
Page 2: ......
