Turning the scanner ON/OFF
25
Main power switch
The main power switch is at the back of the scanner. Press the left side of
the switch (m
arked “I”) to turn the main power to ON. Press the right side of
the switch (marked “0”) to turn the main power to OFF.
Main power switch is at the back of the scanner. Press “I” for ON and “0” for OFF.
Self-test procedure
When you turn the main power ON the scanner will run a short self-test that
takes less than a minute. The LEDs on the panel will light during the self-
test.
All LEDs are on during self-test.
Scanner ready to scan
The scanner is ready for scanning when the power LED turns green. The
scanner starts up in
Wake
mode (see next section).
Scanner ready
– in Wake mode.
You can leave the main power switch permanently ON and control scanner
power through its
Sleep
and
Wake
modes.
