Page 7
1000W DMX smoke machine with HF remote control and Timer
English
6 - Preparation and maintenance
7 - Technical specifications
DMX Addressing
To be controlled via DMX devices, each unit needs its own DMX address so the remote control does not send
information to untargeted units.
Your Smotec1000 only requires one channel.
Configure your dipswiches 1 to 9 in order for your units to receive the DMX signal. Please refer to the table below
to learn about the matches between DMX addresses and the dipswitches binary code.
Dipswitches
#1
#2
#3
#4
#5
#6
#7
#8
#9
Decimal value
1
2
4
8
16
32
64
128
256
Example:
Address 1: Activate dipswitch #1 (value 1)
Address 9: Activate #1 and #4 ( value 1+8=9)
• Smoke output: 283m3 / minute
• Heater: 1000W
• Pre-heat time: 12 minutes
• Fluid tank: 2.8 litres
• Regular fluid consumption: 2.5 litres / hour at 100%
• Electronic management of fluid quantities
• Remote control: On /Off
• Remote control batteries : A27S DC 12V
• Remote control: Smoke projections duration and interval from 5 to 200 seconds
• DMX Channel : 1
• Power supply: 230V - 50Hz
• Power consumption: 1100W max.
• Dimensions: 468 x 250 x 148 mm
• Net weight: 11.4 kg
Preparation
• Fill the tank with smoke fluid. We strongly recommend to use the Contest
®
HD5L
smoke fluid. It was designed
to be used with the Smotec series and guarantees the best visual effects, with a very fast smoke dissipation.
•
Your Smotec1000 and the HD5L fluid have been designed and optimised to be combined together.
Using any other smoke fluid will void the warranty of your smoke machine.
• Connect the power cord of your smoke machine to an electrical outlet. If necessary, position the circuit-
breaker power switch on «On».
• Connect a DMX cable from a universal DMX remote control to use it in DMX.
• Please wait approximately 12 minutes for the heater to reach its operating temperature.
Storage and cleaning
• Once done with your Smotec1000, please unplug it and empty the tank.
• Pour a small amount of deionised water into the tank, plug the machine again and use it as if it was smoke
fluid, until there is no water left in order to ensure an optimal lifespan.
